Programming Mode - Kichler 16027 Manual Del Usuario

Ocultar thumbs

Tabla de contenido

Idiomas disponibles

To change light output setting:

READ SAFETY INSTRUCTIONS AND CAUTION

STATEMENTS AND COMPLETE INSTALLATION

INSTRUCTIONS ON PAGE 1 BEFORE CHANGING

LIGHT OUTPUT SETTING.

•

NOTE: Fixture switches up in terms of lumen settings; it

starts at medium (200 lumens). If this level is desired, no

adjustment is needed.

•

Locate the dimple at the top of the fixture. (This is called a

lumen adjustment switch locator)

•

Hold magnet on lumen adjustment switch locator for 1.5

seconds to begin programming mode. Remove magnet.

•

Fixture will blink continuously 4x's at full brightness level and

go dark for 2 seconds and then will illuminate at original

factory setting.

•

To switch lumen settings, magnet must be reapplied to

lumen adjustment switch locator for 1.5 seconds and magnet

must be removed for 1 second between switching.

•

NOTE: fixture blinks 1x for the lowest lumen setting; 2x's for

the middle lumen setting, and 3x's for the highest lumen

setting.

•

Once the fixture is set and magnet removed, it stays in

programming mode for 2 minutes.

•

After 2 minutes, the memory is set. The fixture must have

power to it for these 2 minutes for the program memory to be

set.

•

To change the output brightenss, return to programming

mode by holding magnet on magnetic locator for 1.5

seconds.

•

NOTE: Fixture reverts back to original factory setting when

put back into programming mode.

•

NOTE: Once the desired setting is set, mark the level (1, 2,

or 3) with a marker on fixture under the cowl.

LUMEN ADJUSTMENT

SWITCH LOCATOR

SWITCHING

MAGNET

CONFORMS TO ANSI/UL STD. 1838

For warranty information please visit: kichler.com/customer-care/warranty-information/landscape-warranty