Nozzle Connection - Mi-T-M HMT-4004-0MGH Manual Del Operador

QUICK-CONNECT NOZZLES:
Various nozzles may be quick-connected into the end of the dual lance to change the spray pattern. The detergent
nozzle has been pre-installed at the factory. When using quick-connects (Q.C.), be certain the connection is securely
locked as shown at right. If not, the high pressure water may shoot the nozzle from the lance, causing severe injury
or serious damage. To determine spray fan, refer to the actual number stamped on the nozzle. The first two digits
indicate the spray fan degree: 00=0°, 15=15°, 25=25°, 40=40°, 65=65°.
1. The 0° nozzle (RED):
This is a blasting nozzle. It delivers a very concentrated stream of water. Be cautious when using the straight narrow
stream. It is not recommended for use on painted or wood surfaces or items attached with adhesive backing. Uses:
Removing weeds from sidewalk cracks, stubborn stains from concrete, masonry, aluminum and steel, caked mud
from equipment, and cleaning lawn mower undersides.
2. The 15° nozzle (YELLOW):
This is a chiseling nozzle. The spray should be directed at a 45° angle to the surface and used like a scraper to
remove paint, grease and dirt. Uses: Surface preparation (removing mildew stains and paint chips).
3. The 40° nozzle (WHITE):
This is a wash nozzle. This wide spray pattern disperses the water pressure over a large area and is recommended
for moderate washing. Uses: Washing aluminum siding, cleaning windows, washing vehicles, spraying sidewalks,
driveways, and patios.
4. The 25° nozzle (GREEN):
This is a flushing nozzle. This pattern is best suited for flushing dirt, mud, and grime. Uses: Wet sweeping leaves
from walks, curbs and driveways, cleaning stable floors, washing swimming pool bottoms, degreasing engines.
5. The 65° nozzle: (included in dual lance.)
This is a detergent nozzle. The broad spray pattern distributes solution over vast areas. Uses: Detergent application,
misting or rinsing.

NOZZLE CONNECTION:

1. Ensure the trigger gun is locked in the OFF position.
2. Quick-connect nozzles can be connected or disconnected from the dual lance assembly by retracting the locking
ring on the quick-connect fitting. When connecting the desired nozzle, push the locking ring over the quick connect
nozzle to secure connection.
16
INSTALLATION & PREPARATION
NOZZLES
NOZZLE CONNECTION
NOZZLE LOCK
HMT-4004-0MGH Operator's Manual