Care Instructions; Product Servicing - IKEA TRÅDFRI Manual De Instrucciones

ENGLISH
HOW TO STEER YOUR LIGHTING
The switch on your power supply cord
will make it possible to turn ON/OFF all
products connected to the TRÅDFRI driver,
but if you want to dim or connect your
products to IKEA Smart lighting products,
you need to buy a separate TRÅDFRI
steering device (e.g. a remote control).
The TRÅDFRI steering device needs to be
paired with your TRÅDFRI driver/s. If you
have more than one (1) driver you can pair
each one with the steering device, so that
the entire combination can be turned ON/
OFF or dimmed at the same time.
Depending on how easy it will be to access
the driver please consider to pair the
TRÅDFRI driver/s with your steering device
before the final placement of the driver/s
and cords.
PAIRING A STEERING DEVICE
TO YOUR DRIVER
1. Connect at least one (1) product to the
driver before you begin the pairing.
Make sure that the power supply cord
is connected to a power socket and that
the switch on the cord set is turned ON.
2. Locate the pairing symbol
driver. Hold the steering device close to
the pairing symbol (no more than 5 cm
away).
3. Press and hold the pairing button
on the steering device for at least 10
seconds. A red light will shine steadily on
the steering device.
The product connected to the driver
will begin to dim and flash one time to
indicate that the driver is being paired to
the steering device.
HOW TO FACTORY RESET YOUR DRIVER
If the driver does not respond or if you
want to un-pair the driver from a steering
device you might have to make a factory
reset. The driver is forced to factory reset
by carefully inserting a paper clip end or
similar in the small hole (marked RESET) in
the driver enclosure and applying a slight
pressure.
IMPORTANT!
— The driver is for indoor use only and can
— Do not leave the driver in direct sunlight
— Do not subject the driver to wet, moist
— The declared radio range between

CARE INSTRUCTIONS

To clean the driver, wipe with a dry soft
cloth.
Never use abrasive cleaners or chemical
solvents as this can damage the product.

PRODUCT SERVICING

Do not attempt to repair this product
yourself, as opening or removing covers
may expose you to dangerous voltage
points or other risks.
on the
TECHNICAL DATA 30 W
Type: ICPSLC24-30NA-IL-1
Input voltage: 100-120Vac, 50-60Hz
Output voltage: 24Vdc
Max output power: 30W
For indoor use only
Radio range: 10 m in open air.
Operating frequency: 2405-2480Mhz
Output power: 14 dBm
be used in temperatures ranging from
5ºC to 45 ºC.
or near any heat source, as it may
overheat.
or excessively dusty environments as
this may cause damage.
the driver and the steering device is
measured in open air. Different building
materials and placement of the units
can affect the wireless connectivity
range.
4