1. The power cord can be
wrapped around the cord
wraps provided on the top of
the tank cover located in front
and behind the handle.
(See Figure 13)
2. To remove the cord from the
cord wraps, grasp the sides
of the rear cord wrap located
behind the handle. Turn
counter-clockwise 180° until the
tip of the cord wrap is above
the handle. (See Figure 14)
3. Grasp the entire cord behind
the handle and pull above
the rear cord wrap. Pull cord
towards the front of the vacuum
until the cord becomes
disconnected from the front
cord wrap. (See Figure 15)
BEST
High Efficiency Collection Filter Bags
• Dry pickup only
• Fine dust and particles
• Easy to install and use
• Reduces loss of suction
**Ultra Web is a registered trademark of Donaldson Co., Inc.
PAGE 7 OF 24
Figure 13
Figure 14
Figure 15
Ultra Web® Cartridge Filter**
• Wet or dry pickup
• Easy cleanup
• Fine dust and particles
FILTER COMBINATIONS
CAGE FILTERS
Cartridge Filters
Foam Sleeve
STORAGE
4. Grasp the sides of the rear cord
wrap and turn clockwise 180° to
return it to its original position.
(See Figure 16)
5. The hose holder may be used
for easy storage of the hose.
Remove accessory from end
of hose. With hose connected
to tank inlet and front of unit
facing you, wrap hose around
top of the tank cover in a
clockwise direction. Secure end
of hose by clipping it in the hose holder attached to
right side of tank cover. (See Figure 17)
6. Never allow liquids to sit in the tank for any extended
period of time. The vacuum should be stored
indoors.
FILTERS
BETTER
TANK FILTERS
PLUS
High Efficiency Collection Filter Bags
Figure 16
Figure 17
GOOD
Foam Sleeve
• Wet pickup only (when used alone)
• Can be used in place of cartridge filter
for dry pickup when used with filter bag.
0521 IH-5814