Publicidad
Step 8
Carefully stand your desk upright.
å
Insert the remaining PIVOT HINGE (25H) into the
å
WASHER (9I) and into the DESK BOTTOM (E).
Insert the PIVOT HINGE, which is fastened to the DESK
å
DOOR (I), into the hole in the DESK SHELF (G). You will
need to tilt your DOOR slightly.
Now, tip the DESK DOOR (I) in and fasten the free PIVOT
å
HINGE (25H) to the DESK DOOR. Use a BROWN 7/16"
LARGE HEAD SCREW (6S).
NOTE: To make adjustments to the DESK DOOR, loosen
å
the SCREW in the HINGE, make needed adjustments, and
tighten the SCREW.
Fasten the PULL (45K) to the DESK DOOR (I). Use two
å
SILVER 3/4" MACHINE SCREWS (53S).
www.sauder.com/services
BROWN 7/16" LARGE HEAD SCREW
(1 used for the PIVOT HINGE)
G
E
6S
25H
9I
415817
53S
SILVER 3/4" MACHINE SCREW
(2 used for the PULL)
45K
Page 11
Publicidad
