Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
CONTROL UNIT
1
Jump start & 12V DC power On/Off switch
2
Built-in light
3
Digital display
4
Battery voltage and % indicator button
5
Warning LED
6
USB Ports (x2)
7
Built-in light & USB power On/Off
8
USB power On/Off
9
220V power outlet On/Off button
10 Jump start cable with clamp (plus)
11 Jump start cable with clamp (minus)
12 12V DC power outlet ports (x2)
13 220V AC household power outlet ports (2)
14 Replacement fuse
15 Air compressor hose
16 Replacement screws for rear panel
17 Charger
18 Ball inflation adaptor
19 Inflation adapters
14 Position of 12V fuses (under rear panel)
15 Air compressor hose
16 Rear panel screws (6 pieces)
20 Air compressor On/Off button
21 Air compressor gauge
22 Charging port (15V/1A)
CHARGING
This product is partially charged from the manufacturer. Fully charge the unit immediately after purchase.
In order to prolong the product life, be sure to fully recharge the unit after each jumpstarting, or every one
month even if this unit has not been used. Recharge the unit as soon as possible to be activated and fully
charge it to ensure long battery life. In addition, we recommend not to charge and discharge the unit at the
same time.
CHECKING THE LEVEL OF THE INTERNAL BATTERY
To check the internal battery's charge status, press the Battery Voltage and % Indicator button (the screen
will turn off in 10 seconds). Charge the internal battery if the display shows it is under 100%.
Note: The internal battery's percent of charge is most accurate when the jump starter has been
disconnected from all devices and charging sources for a few hours.
AC CHARGING
1.
Insert AC charging adapter into charging jack of the unit.
2.
Plug the other end of AC charging adapter into a wall socket.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
Publicidad
Tabla de contenido
