Safety Instructions - BGS technic 3383 Manual Del Usuario

Jump Starter & Portable Power Supply
SPECIFICATIONS
Battery Type: Lead-Acid
Battery Capacity: 18 Ah
Jump Start Peak Current: 1250 A
Built-In LED Light: 2.5 W
USB Output: 5V/2A (2 Ports)
12V Output: 10A (max. 15A) (2 Ports)
220 Voltage AC Power Inverter
Output: Modified Sine Wave (2 Outlet ports)
Continuous Power: max. 400W
Peak Power: 800W
Air Compressor: max. 10.3 bar (150 psi)
Operating Temperature: -30°C ~ +50°C
Charging Temperature: 0°C ~ +40°C
Storage Temperature: -15°C ~ +40°C
Please read and understand all important safety and operating instructions before using this device. In
addition, please read and follow all battery and vehicle manufacturer's instructions and cautionary
markings.

SAFETY INSTRUCTIONS

• Use this device for jumpstarting a 12V LEAD-ACID battery only. Do not attempt to jump-start a
vehicle with a non-rechargeable or defective battery.
• Working in vicinity of a lead-acid battery is dangerous. Batteries generate explosive gases during
normal operation. Use in well-ventilated area. Battery acid can cause permanent blindness. Avoid
touching eyes while working near battery.
• Do not smoke, strike a match, or cause a spark in vicinity of battery or engine. Avoid explosive gas,
flames and sparks.
• Remove all personal jewelry, such as rings, bracelets, necklaces, and watches before jumpstarting
operations. These items may produce a short circuit that can cause severe burns.
• To avoid damage to the vehicle's electrical system, do not use the device on a vehicle that has no
battery installed.
• Use of an accessory not recommended or sold by the manufacturer may result in a risk of fire,
electric shock or injury to persons. Do not operate with damaged accessory(s).
• Locate this device as far away from battery as jumper cables permit.
• Do not expose to rain or wet conditions.
• To reduce the risk of damage to electric plug and cord, pull by the plug rather than the cord when
disconnecting.
• Operate with caution if the jump starter has received direct hit of force or been dropped. Have it
checked and repaired if damaged.
• Any repair must be carried out by the manufacturer or an authorized repair agent in order to avoid
danger.
• This unit contains a sealed, non-spillable lead-acid battery. Must be disposed of properly.
• To prevent arcing, never allow the clamps to touch together or to touch the same piece of metal.
• Ensure that the battery clamps are securely clipped on the storage holders when this device is not
used for jumpstarting.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
BGS 3383
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed