BGS technic 2197 Manual Del Usuario página 18

Push "Zero" button for 2 seconds.
8.
Calibration value will be set.
OPERATION
1. Keep the meter away any substrate or any magnetic field. Pull the trigger to power on, and wait
for "run" and
2. Press the sensing tip to contact coated surface tightly.
3. Pull the trigger and release immediately.
NOT remove the sensing tip from surface until
4. Substrate material will be indicated accordingly. If the substrate material can not be recognized,
"Ferr" and "Non-Ferr" are not shown.
5. Use "MAX/MIN" key to switch maximum, minimum, max-min, average, and number of data log.
MAINTENANCE
Battery Replacement
1. Power is supplied by a 9 volt "transistor" battery (NEDA 1604,
IEC 6F22).
2. Pull off battery cover " ".
3. Remove the battery cover by gently sliding it onwards the
bottom of the meter.
4. Remove and disconnect the old battery from the meter and
replace with a new unit. Wind the excess lead length and put
the top of battery beneath the battery chamber. Install the
battery and put the battery cover.
Cleaning
Periodically wipe the case with a damp cloth and detergent, do not use abrasives or solvents.
Environmental Protection
Recycle unwanted materials instead of disposing of them as waste. All tools,
accessories and packaging should be sorted, taken to a recycling centre and disposed
of in a manner which is compatible with the environment.
Disposal
Do not dispose battery in household waste.
Batteries should be disposed of in a responsible manner, they must be disposed at
appropriate collection point.
Dispose of this product at the end of its working life in compliance with the EU
Directive on Waste Electrical and Electronic Equipment. When the product is no longer
required, it must be disposed of in an environmentally protective way. Contact your
local solid waste authority for recycling information or give the product for disposal to
BGS technic or to the dealer where you purchased the product.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
sign.
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
sign will appear when measurement is completed. DO
sign is shown.
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed