Block Diagram; Safety Instructions And Warnings; Intended Purpose; Start-Up - Kübler CODIX 533 Manual Del Usuario

1.4 Block Diagram

1.1
1.2
1.4
1.3
Inputs
1.1: PWR+ (10...30V DC)
1.2: PWR- (GND)
1.3: PWR- (GND)
1.4: HOLD

2. Safety Instructions and Warnings

1. Before carrying out any installation or
!
maintenance work, make sure that the
power supply of the digital display is
switched off.
2. Only operate this device according to its

intended purpose.

3. It must be in perfect technical condition.
4. Use this device in accordance with the
instructions of the operating manual and
the general safety notes.
5. Take into consideration the provisions
specific to the country of use and to the
user.
6. This device is not suitable for areas
subject to explosion hazards, nor for the
operating areas excluded in standard
EN 61010-1.
7. The digital display can only be operated
as a properly built-in device, according to
the chapter "general technical data".
2.1 Intended Purpose
This device shall only be operated as a built-in device.
Its fields of application are industrial processes and
controls for manufacturing lines in the metal, wood,
plastic, paper, glass and textile industry, and similar
applications.
Overvoltages at the screw terminals of the device
must be limited at the values of the overvoltage
category II.
If the device is used for monitoring machines or pro-
cess flows, in which a breakdown of the device or an
operating mistake might lead to machine damages or
operator accidents, the user must take suitable safety
measures.
EN - Page 3
DC
DC
µC
D
A
Outputs
1.5: I OUT+ (0...24mA)
1.6: PWR- OUT (GND, OUT)
1.7: U OUT+ (0...12V)

3. Start-up

After powering the device, the following message is
displayed for 2 seconds:
Then the device type is displayed for 2 seconds,
followed by the software version, also for 2 seconds.
After reading the EEPROM, the device switches to the
operating mode.

3.1. Reset, Back to Factory Setting

Press both keys simultaneously and power the device:
the following message appears on the display:
The device is reset to the factory settings and is now
ready for operation.
3.2. Programming and Operation of the Setpoint
Generator With the 2 Keys
⇑ ⇑
While programming, press both keys simultaneously
to switch over to the following parameter.
Within a parameter, confirm an input also by pressing
both keys.
⇑
The right key allows selecting the values of the para-
meters. To input a numerical value, select the decade
with the left key
1.7
1.6
1.5