Cleaning - Panasonic ER-GN70 Manual De Instrucciones

Cleaning

Wet cleaning
1. Wet the outer blade with water, and
apply some hand soap and some water
to the outer foil.
2. Slide the power switch to the "O"
position, and let it foam for
approximately 10 seconds.
3. Turn off the power.
▼
To clean lightly dirty parts
• Quick cleaning
4. Open the water inlet (see
page 12) and turn on the
power again.
• If the trimmings box is
removed, open the water
inlet after attaching the
trimmings box (see page 14).
5. Pour water through the
water inlet at the " "
above the "
well and slide the power
switch to the "I" position.
▼
6. Wipe off water with a towel or
similar item, and let it dry naturally.
• It will dry faster with the blades and
the trimmings box removed (see
pages 12 and 14).
10
To clean heavily dirty parts
• Complete cleaning
4. Slide the power switch to
5. Remove the blades and
" mark, rinse
▼
the "I" position.
the trimmings box (see
pages 12 and 14) and rinse
under running water.
• Cover the drainage outlet of
washbasin to prevent the
inner blade from flowing
away.
▼