Fig. 8
Fig. 9
5. Using the Jet Lance
WARNING: The Operator must hold the Jet Lance with both
hands. It is dangerous to attempt to use the Jet Lance with
one hand. A hand grip is provided approximately half way
down the Jet Lance wand. (Fig. 8)
Note: The output pressure of the Jet Lance is dependent
upon the speed of the engine.
• Release the trigger safety locking lever.
• Gently squeeze the trigger to allow the high pressure
water through the lance.
Note: We recommend that any adjustment to the Nozzle
setting is completed before water is allowed to flow through
the lance.
WARNING: The operator should never allow either of their
hands to be in front of the Jet Lance Nozzle. The Lance
must never be pointed at another person or animal or at any
electrical socket etc.
6. Detergent Application
Note: We recommend that only high quality, low foaming,
biodegradable detergent that is specifically formulated
for use in pressure washers is used in this machine. The
operator should follow the manufacturers advice on the
application and handling of the product. Avoid skin contact
with the detergent.
A detergent reservoir is incorporated into the external frame
of the power washer module. (Fig. 9). When required this
reservoir should be filled with high quality detergent specially
formulated for use in power washers. Do not pre-wet the
area to be cleaned as this will only dilute the detergent and
reduce its cleaning ability. Allow the detergent to remain on
the surface for a few minutes before rinsing with the Jet
Lance set to 'high pressure mode'.
Note: Detergent application is automatic but will only occur
when the Jet Lance is in 'low pressure' mode. (Refer to 4.
The Lance Nozzle above)
The reservoir is 'see - through' so that the operator can
monitor detergent usage.
www.evolutionbuild.com
CZ
®
DA
DE
EL
ES
FI
FR
GB
IT
NL
NO
PL
PT
RU
SK
SV
145