Winter Storage; Environmental Protection - Evolution EVOSYSTEM Manual De Instrucciones

Fig 10
(arrows show inner wall
of annular ring)
Fig. 11
146
®
MAINTENANCE AND WINTER STORAGE
Some limited maintenance is required to ensure that your
pressure washer gives good service for many years.
• Keep the annular ring scrupulously clean and free from
debris. (Fig. 10)
• Keep the 3 locating pins and 2 stabilising pins clean and
occasionally spray coat with a silicone oil based spray. (Fig. 11)
• Keep all Uni-coupling mating surfaces clean and free from
dirt or debris.
• At every connection or disconnection check the accessory
drive cog for dirt or debris contamination, particularly between
the teeth. Clean and lubricate as per the instructions for the
engine drive clutch.
• Whenever the accessory is 'remote' from the engine the
coupling protection cover (provided) should be used to
protect the coupling.
• Avoid spraying cog teeth with silicone oil.

Winter storage

We recommend that both hoses (water input and high
pressure water output) are removed from the pump.
Drain the pump body of any residual water by tipping the
pump on its side. Any water left in the pump body will drain
through the pump outlet port. .
Drain the detergent reservoir.
Store in a secure, frost free, dry location, covered by a clean
cloth to prevent the ingress of dirt, debris etc.
We recommend that the two hoses (water inlet and high
pressure) are also drained of any residual water before
being coiled and placed into a suitable plastic bag for winter
storage. The Jet Lance should also be drained of water and
stored in a suitable plastic bag. The Lance can be dismantled
into its two main parts if this makes storage easier.

ENVIRONMENTAL PROTECTION

Waste electrical or mechanical products should not be
disposed of with household waste. Please recycle where
facilities exist. Check with your Local Authority or retailer for
recycling advice.
www.evolutionbuild.com