Service Interface - Pfannenberg DTS 6801 Serie Instrucciones De Servicio

ENG
5.4

Service interface

Fig. 21: Service interface
1 Service interface on the controller
The service interface enables operating parameters to be changed.
•
A USB adapter and the configuration software ECoolPLANT 2.X, including the USB driver software are required for this.
•
The connection for the USB adapter is marked on the circuit diagram with the device tag X28.
•
The USB adapter enables connection to a computer that operates with the configuration software ECoolPLANT 2.X.
–
The USB adapter is available as an accessory, see section "Spare parts and accessories", Page 65.
–
Remove the USB adapter from the unit after use. The service interface is only intended for temporary data
exchange, e.g. to read out system messages. Continuous operation is forbidden.
NOTE
•
•
NOTE
For a detailed description of the error messages and troubleshooting notes, see section "Error messages", Page 58.
Operating Manual | Attachment and Installation Cooling Units | Multi Controller (MC) – 400 / 460 V, 3~ | 086100008f
The ECoolPLANT software is available as a free download on the website www.pfannenberg.com/.
Alternatively, simply scan the QR code opposite.
The appropriate operating manual for the ECoolPLANT software is available for downloading under
My Pfannenberg
2 USB adapter
48/68