Installing The Door - HAMPTON BAY 326 254 Guía De Uso Y Mantenimiento

Assembly (continued)
9
Installing the mantel top
Locate the Mantel/Top (G) and lay the finished side up
on top of the completed assembly.
From the inside, attach the Mantel/Top (G) using
Bolts (AA) through the pre-drilled holes in the Plastic
Connector (KK). Hand tighten only.
AA
G
11

Installing the door

Locate the Right Front Door (M) and Left Front Door (L)
and slide door hinge keyhole into panel hinge bracket.
(Diagram 1)
Use a Phillips Head Screwdriver to tighten screws.
(Diagram 2)
TO ADJUST HINGES:
To adjust door forward or backward change
keyhole slot position. (As Shown In Diagram 3a)
To adjust door right or left loosen/tighten
screw. (As Shown In Diagram 3b)
To adjust door up or down adjust bracket height.
(As Shown In Diagram 3c)
Attach the Knob (FF) to the Left Front Door (L) and
Right Front Door (M), using the bolts attached through
the pre-drilled holes in the doors.
Use a Phillips Head Screwdriver to tighten the bolts.
10
KK
10
Installing the back panel
Attach the Side Back Panel (K) and the Center Back Panel
(Q) to the back of the completed assembly from step 9.
Using a Phillips Head screwdriver, tighten Screws (EE)
through the pre-drilled holes in the Back Panels to the
completed assembly.
Use a Phillips Head Screwdriver to tighten the bolts that
were left hand tightened.
K
L
EE
Q
K
M
FF