HAMPTON BAY 326 254 Guía De Uso Y Mantenimiento página 12

Assembly (continued)
14
Installing the L corner brace
Locate the L Corner Brace (O) and Top Corner Extension
(P) and set out face down on a scratch-free surface.
Insert Bolts (AA) through the holes in the Plastic
Connector (JJ) and tighten.
15
Installing the top corner extension
Attach the completed assembly from step 14 into
place at the back of the mantel.
Insert Wood Dowel (CC) into the holes in the back of the
Top Mantel (G).
Use a Phillips Head Screwdriver to tighten Bolts (AA)
through the Plastic Connectors (JJ and KK).
CAUTION:
Cold climate installation recommendation: When installing this unit against a non-insulated exterior wall or chase, it is
mandatory that the outer walls be insulated to conform to applicable insulation codes.
CAUTION:
A 15-Amp, 120-V, 60 Hz circuit with a properly grounded outlet is required. Preferably, the fireplace will be on a dedicated
circuit as other appliances on the same circuit may cause the circuit breaker to trip or the fuse to blow when the heater is in operation. The
unit comes standard with 6-ft. three-wire cord, exiting from the rear of the fireplace. Avoid using an extension cord. If an extension cord must
be used, it must be a minimum 14 AWG, three wire with grounding type plug connector and rated not less than 1875 watts. Do not use an
extension cord more than 20 ft. in length.
O
KK
AA
JJ
AA
12
AA
P
CC
JJ