Assembly Instructions; Tools And Parts; Stool Use Requirements; Unpack The Stool - Gladiator GAAC30STJB Instrucciones De Ensamblaje

Tools and Parts

Gather the required tools and parts before starting installation.
Tools Supplied
10 mm wrench
■
Parts Supplied
Upper leg frame
■
Lower leg frame
■
Smaller ring
■
Larger ring
■
Swivel plate
■
Seat
■
M6 - 1.00 M6 - 1.00 x 14
Flanged Pan-head
Nut (4) Allen screw (8)
1. Stand up leg assemblies
Stand the lower leg frame upright with the center flat section
facing upward. Place the upper leg frame, with the center flat
section facing down, over the top of the lower leg frame as
shown.
Allen is a registered trademark of Apex Brands, Inc.
†®
4

ASSEMBLY INSTRUCTIONS

5 mm Allen Wrench
®†
■
M6 - 1.00 x 14 Pan-head Allen
■
screw (8)
M6 - 1.00 x 20 Pan-head Allen
■
screw (4)
M6 - 1.00 x 30 Pan-head Allen
■
screw (4)
M6 - 1.00 Sleeved Allen nut (8)
■
M6 - 1.00 Flanged nut (4)
■
M6 - 1.00 x 28
M6 - 1.00
Pan-head
Sleeved Allen
Allen screw (8)
nut (8)

Assemble Legs and Seat

Stool Use Requirements

Intended for use in a garage.

Unpack the Stool

1. Unpack the legs, seat and parts from the box. Verify contents.
See "Parts Supplied."
2. Remove the cardboard packing and set aside for use during
assembly. After completion of assembly, dispose of all
packaging materials properly.
NOTE: Place the cardboard packing on a level floor and use
during assembly to protect the stool from scratches.
2. Attach larger ring
Keeping the leg assembly upright, position the larger ring
over the top of leg frame and move down to align with the
lower holes in the sides of the legs. Insert four M6 - 1.00 x 14
Pan-head Allen screws through the larger ring then through
the leg. Insert four M6 - 1.00 Sleeved Allen nuts and finger
tighten.