Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Attach the Bottom Panel
F1
#10-24 x 1/4"
long Phillips-head Screw (4)
1. Place the bottom panel (upside down so the mating edges are
pointing up), and make sure that the four tabs and slots are
fully engaged.
2. Attach the #10-24 x 1/4" long Phillips-head screws (F1)
between the back panel (P5) and the bottom panel (P4). Do
not fully tighten the Phillips-head screws.
P1
3. Install and tighten the four #10-24 wing nuts (F2) (hand tight)
onto the protruding screw threads (included on the bottom
panel) at each of the four corners.
4. Install the leveler feet (P6) to the bottom panel (P4).
5. Tighten all #10-24 x 1/4" long Phillips-head screws (F1) and
all remaining loose screws from the previous steps.
P6
P6
P1
F2
#10-24 wing nut (4)
P4
P5
P2
F1
F2
P4
P5
P2
Assemble Shelves (Optional)
Use two or more people to move, assemble or install
cabinet.
Failure to do so can result in back or other injury.
Use two or more people to turn the storage/shoe bench over to
an upright position. Install the shelf (P7) at the desired location.
Insert both tabs fully into the slots at an angle, and then straighten
shelf to fully engage the slots in the tabs.
P7
P7
P1
F1
P6
Install Doors (Optional)
1. Assemble the right-hand door (P9) first, as you face the front
of the storage/shoe bench.
2. Engage the door top with the rail by placing the two top pins
into the guides, and then push the pins in (collapse) against
the rail.
3. Swing the door bottom down and push in to make the rollers
engage into the bottom rail. Slide the door back and forth
several times to ensure the door is engaged completely.
P6
P7
P7
P1
P6
4. Repeat steps 2 and 3 to assemble the left hand door (P8).
Registering Your Product
There are many benefits to registering your product. Find out
more and register your product online at
www.gladiatorgarageworks.com.
Consumers in Canada can call 1-800-807-6777.
WARNING
Excessive Weight Hazard
P2
P5
P4
P2
P4
P9
P3
P6
P3
P6
5
Publicidad
Tabla de contenido
