Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
4
DURANGO
7.
Drill starter holes for tab openings according to scribed areas as shown. Use a 3/32” (2.9mm) bit for the top five slots,
a 3/16” (4.6mm) bit for the lowest four slots and a 1/8” (3.5mm) bit for the two side slots. Be sure to drill both ends
of the slots.
10X
3/32”
(2.9mm)
8X
3/16”
(4.6mm)
8.
Cut through remaining areas of tab openings with a utility knife according to scribed areas as shown.
Discard cut out portions.
11X
9.
Cut out center bezel opening according to scribed areas as shown. Discard cut out portion.
1/21/2011
1 7/8”
(47.9mm)
1 5/16”
(33mm)
4X
1/8”
(3.5mm)
1 1/2”
(39mm)
K6860898
Publicidad
Tabla de contenido
