Kohler STERLING 4700 Serie Guía De Instalación Y Cuidado página 4

#8-18 x 1- 1/2"
Panhead Screw
Adjustable In-line
Wall Jamb
#8-18 x 1-1/2"
Panhead Screw
1. Install the In-Line Panels
Place the adjustable in-line wall jamb against the wall and use a level to plumb the wall jamb
vertically.
NOTE: Make sure that the panel is seated evenly on the threshold. Measure the distance from the front of
the threshold to the outside edge of the wall jamb.
Using the pre-drilled screw holes as a guide, mark the hole locations on the wall.
NOTE: When installing on ceramic tile, use a center punch to nick the surface of the glaze and mark the
hole locations. Tap the center punch lightly with a hammer to avoid cracking the tile. Use a tile or
masonry bit when drilling the holes.
Drill a 5/16" hole at each mark. Use a tile or masonry bit for ceramic tile.
Press and hold the legs of each anchor (provided) together and insert the anchor legs into the
pre-drilled mounting holes.
Repeat for all the anchors.
Thoroughly clean the shower floor ledge and wall.
Secure the wall jamb with #8-18 x 1-1/2" screws.
Fit the tall in-line panel into the adjustable in-line wall jamb.
Slide the in-line connector jamb onto the adjustable in-line connector. Fit this assembly over the
opposite end of the in-line panel.
Repeat these steps for the in-line panel and wall jamb on the other side of the doors. Use the
threshold-to-wall jamb measurement obtained earlier to verify that the two in-line panels are
aligned.
1054391-2-D
5/16"
Diameter Hole
Anchor
Press and hold
legs together.
Anchor
Adjustable In-line
Connector
In-line
Connector
Jamb
4
In-line
Panel
Sterling