ASROCK G43TwinsFullHD Manual De Instrucciones página 21

If you want to overclock the CPU you adopt to FSB1333 on this motherboard, you need to adjust
the jumpers. Please short pin3, pin4 for FSB2 jumper and pin4, pin5 for FSB3 jumper. Otherwise,
the CPU may not work properly on this motherboard. Please refer to below jumper settings.
If you use a FSB1333-CPU and adopt a DDR2 1066 memory module on this motherboard, you
need to adjust the jumpers. Please short pin4, pin5 for FSB2. Otherwise, the CPU and memory
module may not work properly on this motherboard. Please refer to below jumper settings.
If you use a FSB1066-CPU and adopt a DDR2 1066 memory module on this motherboard, you
need to adjust the jumpers. Please short pin2, pin3 for FSB3. Otherwise, the CPU and memory
module may not work properly on this motherboard. Please refer to below jumper settings.
2.7 Onboard Headers and Connectors 2.7 Onboard Headers and Connectors 2.7 Onboard Headers and Connectors
2.7 Onboard Headers and Connectors 2.7 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper
caps over the headers and connectors will cause permanent dam-
age of the motherboard!
FDD connector
(33-pin FLOPPY1)
(see p.2 No. 22)
Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the
connector.
Primary IDE connector (Blue)
(39-pin IDE1, see p.2 No. 7)
connect the blue end
to the motherboard
80-conductor ATA 66/100/133 cable
Note: Please refer to the instruction of your IDE device vendor for the details.
ASRock G43TwinsFullHD Motherboard
FSB1333 / DDR2 1066
FSB1066 / DDR2 1066
the red-striped side to
Pin1
connect the black end
to the IDE devices
2 1 2 1 2 1
2 1 2 1