Optika Italy H Serie Manual De Instrucciones página 17

IP Address
Subnet Mask
Default Gateway
Uncheck the DHCP and select the Unicast item, user still need to set the IP address, Subnet mask and Default
Gateway as shown below:
Uncheck the DHCP and select the Multicast item, user still need to set the IP address, Subnet Mask and Default
Gateway as shown below:
Users must manually configure their IP addresses on the camera and computer side.
The camera side and computer side should be in the same network segment. The spe-
cific settings are shown.
This is usually a private address. Private address is a non-registered address used ex-
clusively within an organization. The internal private addresses retained are listed be-
low: Class A 10.0.0-10.255.255; Class B 172.16.0-172.31.255.255; Class C 192.168.0-
192.168.255.255. The suggested IP address is Class C.
Subnet Mask is used to distinguish network domain from host domain in 32-bit IP ad-
dress.
A default gateway allows computers on a network to communicate with computers on
another network. Without it, the network is isolated from the outside. Basically, comput-
ers send data that is bound for other networks (one that does not belong to its local IP
range) through the default gateway.
Network administrators configure the computer's routing capability with an IP range's
starting address as the default gateway and point all clients to that IP address.
Figure 9 - Manual DHCP in Unicast
Figure 10 - Manual DHCP in Multicast
Page 17