Wlan Mode - Optika Italy H Serie Manual De Instrucciones

5.2.3 WLAN Mode

The PC should be a WLAN enabled one.
• For Windows user (Windows 7/8/10 [32/64 bit]), use ProView.
• For Mac OS and Linux user (Mac OS 10.10 or above or Linux distributions with kernel 2.6.27 or higher), use
LiteView.
• When connecting the camera with a mobile device, the free App is required. Just make sure that the mobile
device uses iOS 11 or higher/Android 5.1 or higher operating systems.
1. Plug the HDMI cable into the HDMI port ③ to connect the C-H4K camera to HDMI display.
2. Plug the USB mouse into USB Mouse port ① to get control of the camera by using built-in software ProView.
3. Plug 12V/1A power adapter into DC 12V slot ⑧ to supply power for the camera. The LED Indicator ⑦ will
turn into red.
4. Press ON/OFF Button ⑥ to turn on the camera. The LED indicator will turn into blue.
5. Move the mouse to the bottom of the UI and click the
of the video window. A small window called Settings will pop up as shown below.
6. Click Network>WLAN property page and choose the AP option in the WiFi Mode edit box (the factory default
configuration is AP mode).
7. Install ProView or LiteView on your PC or install the app on the mobile device.
8. Plug the USB WLAN adapter into the camera's USB3.0 port.
9. Connect the PC or mobile device with the WLAN AP point that the camera provides.
• The network name (SSID) and the WLAN password (default one is 12345678) can be found on the camera's
Setting>Network>WLAN page in AP mode.
10. Start the ProView / LiteView software or the mobile App and check the configuration. Normally, active cam-
eras are automatically recognized. The live image of each camera is displayed.
11. For the display, the Camera List tool window is used in the ProView/LiteView software, and the Camera
Thumbnail is used in the mobile App.
button on the Camera Control Toolbar at the bottom
Figure 2 - WLAN configuration
Page 6