dormakaba BEST Wi-Q Instrucciones De Instalación

Tools Needed Drill
Taladro
Herramientas necesarias
Foret
Outils nécessaires
Gateway
A
Compuerta
Passerelle
Antenna
B
(2x)
Antena
Antenne
Mounting Bracket Assembly
C
Conjunto del soporte de montaje
Assemblage de support de montage
Ceiling Grid Bracket Assembly
D
Conjunto del soporte de la rejilla del techo
Assemblage de support de l'élément plafonnier
#6-32 x 3/4" Machine Screw
E
(2x)
Tornillo para máquina N.º 6-32 x 19 mm (3/4 pulg.)
Vis mécanique no 6 à 32 filets x 19 mm (3/4 po)
#6-19 x 1/4" Retaining Screw
F
Tornillo de retención N.º 6-19 x 6.4 mm (1/4 pulg.)
Vis de fixation no 6 à 19 filets x 6 mm (1/4 po)
AC/DC Power Converter
G
Conversor de alimentación CA/CC
Convertisseur de secteur CA/CC
Ethernet Cable
H
Cable de Ethernet
Câble Ethernet
Omni-Directional Antenna Kit
I
Kit de antena omnidireccional
Kit d'antenne omnidirectionnelle
Integrated Portal Gateway Enclosure
J
Gabinete de compuerta de portal integrado
Enceinte de passerelle avec portail intégré
1
Develop a Site Plan
Create a site plan to define the area you want to control and
the appropriate location of the Gateway. The Gateway should
be installed in a centralized location and near a network
connection.
Transmit range from the Gateway to the controller varies
based on the building construction. Site characteristics such as
reinforced concrete walls could interfere or weaken the signal;
open spaces and low interference can increase signal strength.
Refer to the Wi-Q User Guide for more information.
BEST is a trademark of dormakaba USA Inc.
Drill Bit #2 Phillips
Broca de taladro Screwdriver
Mèche
Destornillador
Phillips N.º 2
Phillips n° 2
Tournevis
B
(2x)
A
2
Position Gateways
Once all the door hardware and controllers have been installed,
you are ready to determine the final placement of the Gateways
using the results from the Wi-Q Site Survey. The Site Survey
helps you determine the number and optimum location of the
Gateways and verify the signal strength before permanently
installing the Gateway hardware. It is important to perform the
Site Survey process as many times as needed to determine the
optimal positions of the Gateways that allow a strong signal
connection to be achieved for all of the locks.
Refer to the Wi-Q User Guide
You will need to test the signal strength at all the door locations
near the perimeter of the coverage area as well as any location
where a physical obstruction may cause interference.
Wi-Q Gateway Installation Instructions
Instrucciones de instalación de la compuerta Wi-Q
Instructions pour l'installation de la passerelle Wi-Q
NOTE: Powered with 110VAC or with PoE,
PoE class 1 device
NOTA: Alimentado con 110 V CA o con PoE,
dispositivo de clase 1 PoE
REMARQUE : Alimenté par 110 VCA ou un dispositif
d'alimentation par Ethernet de classe 1
D
C
Drop ceiling
installation only
solo para instalación
Two #6 x 1/4"set
en techo colgante
screws included
installation sur faux
incluye dos tornillos de fijación plafond uniquement
N.º 6 x 6.4 mm (1/4 pulg.)
deux vis de calage no 6 x 6 mm
(1/4 po) sont incluses
for more information.
1/8
BEST Access Solutions
Knowledge Base
https://support.bestaccess.com/hc/en-us/articles/
201179876-Wi-Q-Hardware-Templates-Instructions
E F
(2x)
Electrical box/IPG Optional to use
installations only
uso opcional
solo para instalaciones
utilisation facultative
en cajas eléctricas/IPG
installations avec boitier
électrique/IPG uniquement
uso opcional,
G
no es necesario si es
alimentado por POE
Optional to use, utilisation facultative,
non nécessaire si
not needed if
alimenté par Ethernet
powered by PoE
no incluido,
H requerido
para la instalación
non inclus,
Not included,
requis
required
pour installer
for install
opcional y
se vende por separado
I
facultatif et
vendu séparément
Optional and
sold separately
Optional and
sold separately
opcional y
se vende por separado
J
facultatif et
vendu séparément
3
Mount Gateways
Once the optimal location of the Gateway has been determined,
the Gateway may be permanently mounted.
The Gateway can be installed on a variety of surfaces, including:
1. Drop ceiling
2. Wall or rigid ceiling (such as drywall,
concrete, paneling, or similar material)
3. Shelf
4. Electrical box
5. Integrated Portal Gateway (IPG) enclosure
A89995_A 2019 All rights reserved.
©