Publicidad
6
INSTALL
ANTENNAS
B
1
(2x)
1
Install the antennas (B
) onto the
(2x)
gateway (A) using 4-6 in-lb torque.
Wall Or Rigid Ceiling Installation
1
ATTACH MOUNTING
BRACKET ASSEMBLY
NOTE:
Anchors and
1
screws not included
1
Attach the mounting bracket assembly (C)
to the wall using the appropriate anchors
and screws.
CONNECT
2
CABLES
A
1
Connect the Ethernet cable (H)
and the DC power cable (G)
to the gateway (A).
4
INSTALL
RETAINING
SCREW
NOTE:
#6-19 x 1/4"
retaining screw (F)
optional to use
Install the #6-19 x 1/4"
retaining screw (F).
BEST is a trademark of dormakaba USA Inc.
A
C
NOTE:
Ethernet cable (H)
H
2
not included, required for
1
install; DC power cable (G)
G
optional to use, not needed
if powered by PoE
2
Route the Ethernet cable (H) and the
DC power cable (G) into the channel
on the bottom of the gateway (A).
F
VERTICALLY ORIENT
ANTENNAS
A
2
The antennas (B
) must be
(2x)
oriented vertically when installed.
ROUTE
CABLES
NOTE:
Ethernet cable (H)
G
not included, required for
install; DC power cable (G)
optional to use, not needed
if powered by PoE
2
If the Ethernet cable (H) and the DC power cable (G)
will be pulled through the wall surface, both cables
must exit the wall in the area shown.
3
SLIDE/SNAP
ON GATEWAY
A
1
1
Slide the gateway (A) onto the
mounting bracket assembly feet (C)
until it snaps into place.
5
INSTALL
ANTENNAS
Install the antennas (B
(2x)
) onto the gateway (A)
using 4-6 in-lb torque. The antennas (B
must be oriented vertically when installed.
3/8
2
B
(2x)
2
2
H
C
2
2
Push any excess cable
back into the wall.
B
(2x)
A
)
(2x)
A89995_A
2019 All rights reserved.
©
COMPLETE
COMPLETE
Publicidad
