EDIFIER R1855DB Manual De Instrucciones página 8

Audio source input
Line In Input
1. Connect the audio cable to the Line In 1/Line In 2 input port on the rear panel of the active speaker (please pay attention to
the corresponding colors), and the other end to the audio source (i.e. PC, mobile phones and etc.).
2. Press the "LINE1"/"LINE2" button on the remote control or press the master volume dial on the rear panel of the active
speaker. The LED indicator on the active speaker turns to green: Line In 1 mode (The light will flash once), Line In 2 mode
(The light will flash twice).
3. Play music and adjust the volume to a comfortable level.
Optical / Coaxial Input
1. Connect the "Fiber optic audio
active speaker and device with optical and coaxial input.
2. Press "OPT"/"COAX" button on the remote control or press the master volume dial on the rear panel of the active speaker.
The LED light on the active speaker turns to red: optical mode (The light will flash once), coaxial mode (The light will flash twice).
3. Play music and adjust the volume to a comfortable level.
Note: In optical and coaxial modes, only PCM signal with 44.1KHz/48KHz can be decoded.
7
English
or
or
cable" or "Coaxial cable" (not included) to OPT/COAX input port on the rear panel of the