Update Of Satellite Data Base - Kongsberg Simrad Marine TV45 Manual

Simrad Marine TV
12. The display interchanges between a flashing
the previously chosen storage position. Confirm with
If you want to abandon the function, press , which interrupts the storage.
The display will briefly show
You may now continue the search, or you can store the satellite just
received at another storage position. (See point 4).
13. If you chose to 'confirm' in point 12, the display shows
ing) for approximately 1 minute. The data of the satellite is now automati-
cally memorized and stored. The display shows:
While the data is being stored, the ship must not move, a permanent clear
view to the satellite must be guaranteed, and the antenna unit must not be
turned off!
14. When the data is memorized, the display shows
moment and then the system automatically jumps to the TV mode of the
just stored satellite (the display shows
tion). The ship can now be moved and the reception tested.
In case a failure occurs and the data is not memorized correctly, the display
shows
Err Save
For each new satellite, the search mode must be repeated! You can store up
to four satellites (TV46/60) or two satellites (TV45).

4.2 Update of satellite data base

Example of update: The Astra satellite was stored in German waters and now
the vessel was sailing in Scandinavian waters. The angles of the satellite has
therefore moved and it takes longer to locate the satellite. To shorten the search
time, new data for the angles has to be stored:
1. To go to the setup menu, press
(flashing), then press
is correct you are in the Setup menu.
2. Press repeatedly until
be stored by pressing
Please keep in mind, that the menu item
tracking function is deactivated (See section 3.1).
3. The display interchanges between
cancel
and the calibration has to be done again.
repeatedly until the display shows
, Enter password, see section 1.5. If the password
Upd Sat
.
Sat
X and
Sat
and then return to
checking
complete
X, where X is the storage posi-
Sat
appears. Now the up-to-date angles can
is not shown, if the
Upd Sat
X (storage position of current satel-
English-19
, where X is
save?
.
.
Sat ok?
(flash-
saving..
.
for a brief
Setup