Disposing Product; Power Switch - NSK Ti-Max NLX nano Manual De Operación

10. Troubleshooting
When trouble is found, check the following again before consulting NSK dealer. If none of these is applicable or the the trouble
is not remedied even after action has been taken, a failure of this product is suspected.
Check/Remedy
Pilot Lamp does not light.
Motor does not run
The rotation speed does not
rise.
It beeps when turn on the
switch.
LED does not light.
Motor heats up abnormally
during rotation.
Water leakage
When turned on, the setting
values are different from
what used to be when
turned off.
11. Warranty
Manufacturer warrants its products to the original purchaser against defects in material and workmanship under normal
practices of installation, use and servicing. are expendable components, and are not covered by this warranty. In case the
product fails within 30 days from the date of installation, immediately report with the proof of your purchase to the dealer you
purchased from.

12. Disposing Product

Consult with dealer from whom you purchased it about waster despoil.
Cause
Power Switch is OFF.
AC Adapter is not connected correctly.
Internal Fuse is blown, due to some reason.
Tubing, Motor Cord, AC Adapter is not connected
correctly.
Air pressure is not given, or not proper from the
delivery unit.
Check the ERROR CODE in the Indicator.
Air pressure is not given, or not proper from the
delivery unit.
Air pressure of the delivery unit is lower than the
"Lower limit of the air pressure".
You are stepping on the Foot Pedal when turning on
the power switch. (Safety function)
Reached the end of life expectancy.
Coolant air is not given, or not proper from the
delivery unit.
Tubing, Motor Cord is not connected correctly.
If it is from Control Box, something is wrong within
the Control Box.
Turned off the motor while rotating.
Turn ON the switch.
Check the connection.
Contact your dealer.
Check the connection.
Check the air pressure of the delivery
system.
Refer to 9. ERROR CODE.
Check the air pressure of the delivery
system.
Do "6- Foot Air Calibration".
Do not step the Foot Pedal, and turn on the

power switch.

Contact your dealer.
Check the air pressure of the delivery
system.
Contact your dealer.
Check the connection.
Turn off after the Motor has stopped.
0
Solution