EGO Power+ CTA9500 Traducción De Las Instrucciones Originales página 9

DESCRIPTION
KNOW YOUR EDGER ATTACHMENT (Fig.A)
1. End Cup
2. Cultivator Attachment Shaft
3. Gear Box
4. Sleeve
5. Outer Blades
6. Inner Blades
7. Hitch Pin
8. Guard
9. Allen Key
ASSEMBLY
WARNING: If any parts are damaged or missing,
do not operate this product until the parts are
replaced. Use of this product with damaged or missing
parts could result in serious personal injury.
WARNING: Do not attempt to modify this product
or create accessories not recommended for use with
this product. Any such alteration or modification is
misuse and could result in a hazardous condition
leading to possibly serious personal injury.
WARNING:
Always wear heavy gloves when
installing or removing the blade or doing any maintenance
on the blade. Be careful of the blade and protect your
hands from being injured by the blade.
WARNING: Do not connect the cultivator to the
power head until assembly is complete. Failure to
comply could result in accidental starting and possible
serious personal injury.
MOUNTING THE GUARD
WARNING: Install the guard before the cultivator
attachment is connected to the power head.
1. Loosen and remove the bolt from the guard with the
Allen key (Fig. B).
2. Lift the cultivator attachment shaft and remove the
end cap from the shaft.
3. Aligned the slot in the guard with metal tab on the
end of the shaft, pass the guard through the shaft
until the screw holes in the guard and in the metal
tab are aligned (Fig. C & D).
4. Use Allen key to tighten the bolt clockwise to lock the
guard securely.
Fig. D parts description see below:
D-1 Bolt
CONNECTING THE CULTIVATOR ATTACHMENT TO
THE POWER HEAD
WARNING: Never attach or adjust any
attachment while the power head is running or with
the battery installed. Failure to stop the motor and
remove the battery may cause serious personal injury.
This cultivator attachment is designed for use with EGO
Power Head PH1400E
1. Stop the motor and remove the battery pack
2. Loosen the wing nut on the power head coupler.
3. If the end cap is on the attachment shaft, remove it
and save it in a safe place for later use.
Align the arrow on the cultivator shaft with the arrow on
the coupler (Fig. E) and push the cultivator shaft into the
coupler until you hear a clear "CLICK" sound(Fig. F).
Fig. E parts description see below:
E-1 Shaft-Release Button
E-2 Arrow on the Coupler
E-3 Wing Nut
E-4 Arrow on the Attachment Shaft
E-5 Red Line
Fig. F parts description see below:
F-1 Red Line
4. Slightly pull the shaft of the cultivator attachment
to verify that it is securely locked into the coupler. If
not, move the cultivator shaft back and forth in the
coupler until a clear "CLICK" sound indicates that it is
engaged.
5. Tighten the wing nut securely.
WARNING: Be sure the wing nut on the coupler is
fully tightened before operating the equipment; check
it periodically for tightness during use to avoid serious
personal injury.
REMOVING THE ATTACHMENT FROM THE POWER
HEAD
1. Stop the motor and remove the battery pack.
2. Loosen the wing nut.
3. With the shaft-release button depressed, pull or twist
the cultivator attachment shaft out of the coupler to
remove it from the power head
CULTIVATOR ATTACHMENT — CTA9500
EN
9