Programme End - Hoover H-Wash 700 Manual Del Usuario

l
The appliance
remaining based on a standard load, but
during the cycle the machine may change
it depending on
composition of the load.

PROGRAMME END

l
After the display shows the cycle has
ended and the DOOR LOCK light has
switched off, you can open the door.
If the REMOTE CONTROL function is
active, the door will remain locked
(and the light
deactivated.
PAUSING THE MACHINE
l
Press PAUSE to stop the ongoing cycle
for a short time.
For safety reasons, in some phases of
the wash cycle, the door can only be
opened if the level of the water is
below the door's lower rim and the
temperature is below 45°C. If these
conditions are met, wait for the DOOR
LOCK icon to switch off before
opening the door.
l
Press the START button again to resume
the programme from where it left off.
CANCELLING A PRESET CYCLE
l
To cancel the programme, press the
STOP button.
l
Wait for the DOOR LOCK light to turn off
before opening the door.
FAVOURITES menu
If you frequently use a programme you
have customised to suit your needs, the
appliance can memorise the settings by
saving it among your favourites, so you can
quickly retrieve it. You can save up to 6
programmes.
calculates the time
the volume and
on) until it
- SAVING
l
Select a
temperature, spin speed and, if required,
choose other options, then press
l
After you have memorised it, it will be
saved among your FAVOURITES in the
home page.
l
Every memorised programme will be
saved in
identified by a number from 1 to 6 (from
the oldest to the most recent).
is
- DELETING
l
To delete
programmes, keep its icon pressed for
approximately 3 seconds and then press
.
Last programme used
The home display screen will always show
the last programme you used, with the
various chosen options, so you can select it
quickly.
Setting the temperature
l
By selecting the specific icon and swiping
along the ring dial, you can change the
temperature of the wash cycles.
To avoid damage to fabrics, it is not
possible to increase the temperature
above the
established for each programme.
.
l
If you want a cold wash, all the lights
must be off.
Setting the spin speed
l
By selecting the specific icon and swiping
along the ring dial, you can reduce the
permitted spin speed in the selected
programme, until there is no spin at all.
82
programme, change
chronological order
one of your
highest temperature
the
.
and
favourite