Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Cequent Performance Products, Inc.
Plymouth, MI 48170
Technical Service: (888) 521-0510
Installation Instructions
Hull-Hugger™ Watercraft Storage Unit | Product Code: 59914
Using the spacing chart on page 2,
determine the approximate distance needed
between the two Hull-Hugger Support Arms (A),
then locate the studs where each arm will be
mounted and determine the desired height.
Once the desired height is found, trace the four
Lag Bolt holes on the wall using a pencil.
Using an electric drill, make a pilot hole
through the wall and into the stud at each
of the four marked spots.
Add a Washer (E) to each Lag Bolt (D).
Page 4 of 9
1
2
3
4
59914N
Rev A
3/15
Publicidad
Tabla de contenido
