If you are not going to secure your watercraft when loaded onto the
Hull-Hugger™, the included Cam Buckle Straps (B) can be looped through each of the
Support Arms to hold an additional watercraft (total system weight limit is 125 lbs.)
under the Hull-Hugger™. Follow steps 12-15 to use Cam Buckle Straps (B) for holding
Cequent Performance Products, Inc.
Plymouth, MI 48170
Technical Service: (888) 521-0510
Installation Instructions
2
1
an additional watercraft.
Hull-Hugger™ Watercraft Storage Unit | Product Code: 59914
With both pivoting Support Arms (A) in the down
position, load the watercraft.
Hang the cam buckle end of the strap up and
over the watercraft as shown.
Feed the end of Cam Buckle Strap (B) up
through the pivoting Support Arm (A).
Insert strap end into the cam buckle.
Pull down to tighten completely until watercraft is
secure, then slide the Cam Buckle Cover (C)
over the cam buckle to protect watercraft during
use.
Repeat steps 7-10 for securing the watercraft to
the second Support Arm (A).
Page 6 of 9
9
10
11
59914N
Rev A
3/15