Stroller Assembly - UPPAbaby CRUZ Manual Del Usuario

STROLLER ASSEMBLY
UNFOLD STROLLER
STEP 1 : Pull latch back with thumb to release locking
mechanism.
CANOPY INSTALLATION AND OPERATION
TO ATTACH CANOPY: Snap each side of canopy
attachment to seat frame above plastic ring.
NOTE: Canopy height is adjustable.
UPPAbaby CRUZ Instruction Manual
STEP 2: Pull handle upward until frame locks open
as shown.
TO ADJUST CANOPY: Slide canopy attachment Slide canopy attachment simultaneously up or
simultaneously up or down the seat frame in between down seat frame for desired height.
two plastic rings for desired height.
4
STROLLER ASSEMBLY
INSTALL FRONT WHEELS
TO INSTALL FRONT WHEELS: Slide wheel post into
housing until it locks into place.
INSTALL BACK WHEELS
TO INSTALL BACK WHEELS: Slide wheel post into
housing until it locks into place.
TO REMOVE FRONT WHEELS: Push button located
on the inside of the front fork and slide wheel off.
TO REMOVE BACK WHEELS: Pull tab down on Slide canopy attachment simultaneously up or
bottom of fork and slide wheel out. down seat frame for desired height.
5
ENGLISH