Uline H-9045 Guia De Inicio Rapido página 3

3. Attach sign to canopy by inserting canopy into sign at
an angle. Twist to secure. (See Figure 9)
Figure 9
4. Feed transformer input leads through center hole
and make the proper connections. (See Figures 2-3)
NOTE: If using 120VAC, connect black and white
leads to building utility.
NOTE: If using 277VAC, connect orange and
white leads to building utility.
NOTE: In some cases, not all leads will be used.
Cap off unused wire.
CAUTION! Battery Connector is shipped
disconnected. Snap connector into
socket at installation. (See Figure 10)
Use Manual Battery Test Switch on side of unit
to test. Red LED indicates normal operation.
(See Figure 11)
PAGE 3 OF 9
INSTALLATION CONTINUED
Canopy
BATTERY
Figure 10
1-800-295-5510
5. Feed excess wire into junction box and align holes
in canopy to crossbar so that canopy is securely
fastened and tight against the ceiling.
6. Snap in arrows to EXIT panel as required. Then snap
EXIT panel to housing: top first, then bottom.
Socket
Battery
Battery
Connector
uline.com
Figure 11
Manual Battery
Test Switch
0221 IH-9045
Red LED