Polk magnifi one Guía De Configuración página 8

IR Remote Learning
For your Sound Bar to respond to your remote control, you MUST FIRST
program the bar to respond to your television's original IR (Infra-Red) remote.
An RF (Radio Frequency) remote will not work. Other remotes (cable, satellite)
will work only after you have programmed the bar to respond to the TV's IR
remote.
Note: The first and third LEDs, followed by the second and fourth LEDs will flash in pairs three times
to indicate a failed learn. The bar will exit learn mode after several unsuccessful attempts to
learn an IR command. Carefully repeat steps 1-3 below.
1
Enter Learn mode by
pressing and holding
the source button for
3 seconds.
Code Erasing Procedure: If you have programmed your Sound Bar to
respond to a remote control and you no longer want it to do so, erase the
codes by pressing the SOURCE key for about 10 seconds while the unit is in
standby mode. The first LED will flash green and then white. This sequence will
repeat three times, and when it's complete you'll know that previously learned
codes have been successfully erased.
For more information visit our website at www.polkaudio.com
2 3
Press the volume Corresponding function should be
up button. pressed repeatedly, and 4 LED's will flash
immediately after each press. LED's will
flash white 3 times within 1 second then
hold solid for 2 seconds for success.
7