Kuppersbusch IKE1780-0E Manual Del Usuario página 11

Problem
The compressor does not
start immediately after
pressing the IntensiveCool‐
ing, or after changing the
temperature.
Water flows inside the refrig‐
erator.
Water flows on the floor.
Temperature cannot be set.
dEMo appears on the dis‐
play.
The temperature in the ap‐
pliance is too low/too high.
Possible cause
The IntensiveCooling is
switched on.
This is normal, no error
has occurred.
The water outlet is clog‐
ged.
Food products prevent
that water flows into the
water collector.
The melting water outlet is
not connected to the evap‐
orative tray above the
compressor.
The FastFreeze function
or IntensiveCooling func‐
tion is switched on.
The appliance is in dem‐
onstration mode.
The temperature regulator
is not set correctly.
The door is not closed cor‐
rectly.
The food products' tem‐
perature is too high.
Many food products are
stored at the same time.
The door has been
opened often.
The FastFreeze function
or IntensiveCooling func‐
tion is switched on.
Solution
Refer to "IntensiveCooling
function".
The compressor starts after a
period of time.
Clean the water outlet.
Make sure that food products
do not touch the rear plate.
Attach the melting water outlet
to the evaporative tray.
Switch off FastFreeze or In‐
tensiveCooling manually, or
wait until the function resets
automatically to set the tem‐
perature. Refer to "Fast‐
Freezefunction" or "Intensive‐
Cooling function".
Keep the OK pressed for ap‐
proximately 10 seconds until a
long sound is heard and dis‐
play shuts off for a short time.
Set a higher/lower tempera‐
ture.
Refer to "Closing the door".
Let the food products temper‐
ature decrease to room tem‐
perature before storage.
Store less food products at the
same time.
Open the door only if necessa‐
ry.
Refer to "FastFreeze function"
or "IntensiveCooling function".
11