Descargar Imprimir esta página

Publicidad

Enlaces rápidos

CC-2
Instructions / Instructions / Anleitung / Instrucciones
PARK TOOL CO.
A worn chain shifts poorly and wears sprockets at an accelerated rate. The
CC-2 Chain Checker provides a precise measurement of chain wear on 5, 6, 7,
8, 9, 10, 11, and 12-speed bicycle derailleur chains.
Instructions
1. Set pivoting gauge so "0" is visible in viewing window.
2. Lower CC-2 so fixed pin rests between chain's inner plates.
3. Lightly push pivoting gauge just until it stops. Forcing gauge will damage
the CC-2's pins, resulting in inaccurate measurements. Read number
in viewing window. Chain replacement is generally recommended at or
before .75% for 5, 6, 7, 8, 9-speed chains and at or before .50% for 10, 11,
12-speed chains. These percentages can vary between chain models, so
contact the chain manufacturer for specific recommendations.
Notes: Because a chain must have a small amount of play in the links to run
smoothly, the CC-2 will show a reading of .25% (or more) on new chains. This
does not mean that the chain is .25% worn. It only means there is .25% play
built into the links of the chain before it starts to wear. No matter what the
reading of a new chain, it should be replaced when the CC-2 shows a reading
of .75% (for 5, 6, 7, 8, 9-speed chains) or .50% (for 10, 11, 12-speed chains).
The length of time and amount of riding it takes to wear a chain is
determined by several factors, including chain quality, riding conditions, and
level of maintenance. As a result, chain life can vary significantly.
1
2
Moveable pin
Beweglicher Stift
Goupille mobile
Perno movible
3
5115 Hadley Ave. N., St. Paul, MN 55128 (USA) www.parktool.com
CC-2 Chain Checker
Pivoting gauge
Schwenkbare Anzeige
Levier pivotant
Medidor de perno móvil
Inner plates
Innere Laschen
Plaques intérieures
Placas interiores
PARK TOOL® and the color BLUE are registered trademarks of Park Tool Co.
Tool body
Werkzeugkörper
Corps de l'outil
Cuerpo de la herramienta
Outer plates
äußere Laschen
Plaques extérieures
Placas exteriores
Fixed pin
Feststehender Stift
Goupille fixe
Perno fijo
© 2016 Park Tool Co.

Publicidad

loading

Resumen de contenidos para Park Tool CC-2

  • Página 1 Notes: Because a chain must have a small amount of play in the links to run smoothly, the CC-2 will show a reading of .25% (or more) on new chains. This does not mean that the chain is .25% worn. It only means there is .25% play built into the links of the chain before it starts to wear.
  • Página 2 0.5% voulu par le fabriquant, pour le bon fonctionnement de la chaine avant que l’usure ne commence. Quelque soit l’indication de départ, la chaine devrait être remplacée lorsque le CC-2 indique une usure de 0.75% (pour les chaines 5, 6, 7, 8, 9 vitesses) ou 50% (pour les chaines 10, 11, 12 vitesses).