Park Tool SG-7.2 Manual De Instrucciones

Park Tool Co.
6 Long Lake Rd. St. Paul, MN 55115 (USA) www.parktool.com
• Accurately guides a hacksaw to cut fork columns, aero seat posts, and integrated seat tubes
• Two cutting slot widths for standard and carbon composite cutting blades
• Works on aero tubes up to 3.5" (89mm) and round tubes from 1-1/4" (32mm) to 1-3/4" (45mm)
Instructions:
1. Mark desired location of cut on tube.
2. Clamp tube in a Park Tool Repair Stand and rotate to the
horizontal position.
3. Slide SG-7.2 on tube until mark is visible through the cut-
ting slot. Use the narrow slot if using a standard hacksaw
blade. Use the wider slot if using a blade specifically
for cutting carbon composite. Tighten handle to secure.
When cutting an aero tube, position narrow part of tube in
center of floating V block (ref. #3).
4. Set blade of hacksaw in cutting slot and saw through
tube. Do not apply excessive pressure on the blade. Keep
hacksaw traveling straight down the slot. Always use a
sharp blade. Use of a dull blade may result in an inac-
curate cut.
5. Loosen handle and slide SG-7.2 on tube to expose cut end
of tube. For metal tubes, finish outside and face of tube
with a flat file. De-burr inside of metal tube with a round
file or de-burring tool. Finish end of carbon composite
tube with fine sandpaper.
6. Remove SG-7.2 from tube.
All manuals and user guides at all-guides.com
Adjustable Saw Guide
2
1
4
3
7
SG-7.2 Oversized
SG-7.2 part numbers
Part No. Description
5
1 796R Body Assembly
794C Handle Assembly
2
3 797 Floating V Block
6
4 795 Fender Washer
798 Lower Washer
5
6 723A Button Head Cap Screw
800-2 Frame Pad
7
8
8 467-1 Retaining Clip
Qty.
1
1
1
1
1
1
2
4