Fence Assembly - KNOVA KN DP-2500N Manual Del Usuario

ASSEMBLY AND ADJUSTMENTS
MOUNTING DRILL PRESS TO WORK SURFACE (FIG. L)
1. If mounting the drill press to a workbench, a solid wood
bench is preferred over a plywood board, to reduce noise
and vibration.
2. Holes should be pre-drilled through the supporting
surface.
3. The hardware to mount this drill press is NOT supplied
with the tool. The hardware as shown in the illustration
should be used:
1. Drill press base
2. Bolt
3. Flat washer
4. Rubber washer
1
5. Worksurface
6. Flatwasher
7. Lockwasher
8. Hex nut
9. Jam nut
FENCE ASSEMBLY (FIG. M)
1. Align the mounting holes of the fence over the table slots.
2. Place a washer (2) on the threaded end of the knob (3).
Insert the knob through the mounting hole of the fence
and the table slot.
3. Place a washer and wing nut (4) on the knob from under
the table.
4. Repeat for the other knob and tighten.
Fig. L
6
5
7
Fig. K
Fig. M
ADJUSTMENTS INSTRUCTIONS
NOTE: All the adjustments for the operation of the drill press
have been completed at the factory. Due to normal wear and
use, some occasional readjustments may be necessary.
2
3
W A R N I N G
4
"OFF" position, the switch key is removed, and the plug is
not connected to the power source outlet before making
belt adjustments.
BEVEL DRILLING (FIG. N)
NOTE: A bevel scale has been included to measure approxi-
mate bevel angles. If precision is necessary, a square or other
measuring tool should be used to position the table. To use
the bevel scale (6):
9
1. TIGHTEN the nut (4) on the locking pin using a 10mm or
8
adjustable wrench clockwise to RELEASE it from the table
support.
2. Loosen the large hex head table bevel locking bolt (5) using
a 17mm or adjustable wrench.
3. Tilt the table, aligning the desired angle measurement to
the zero line opposite the scale (6).
4. Tighten the table bevel locking bolt (5).
5. To return the table to its original position, loosen the table
bevel locking bolt (5). Return the table (6) to the 0° position.
6. Return nut (4) on locking pin to the OUTSIDE END OF
THREADS. Gently tap locking pin until it is seated in the
mating hole of the table bracket. Hand tighten nut (4).
NOTE: The table has been removed form the illustration for
clarity.
9
3
2
4
To avoid injury from an accidental start,
ALWAYS make sure the switch is in the
1