Important - KNOVA KN DP-2500N Manual Del Usuario

ASSEMBLY AND ADJUSTMENTS
INSTALLING TABLE TO COLUMN ASSEMBLY (FIG. B
THROUGH F)
1. Insert the worm gear (1) into the table crank handle hole
(2) from inside the table support (3). Make sure the worm
gear (1) meshes with the inside raising/ lowing gear.
2. Install the table bracket lock handle (4) into the hole at
the rear of the table bracket assembly. NOTE: Install the
handle from left to right, so it enters the non-threaded
side of the table bracket first as shown in Fig. C.
NOTE: Table removed from bracket in illustration for clarity.
Fig. B
3
2
3. Place the rack (5) inside the table bracket (3), making
sure the worm gear (1) on the inside of the table bracket
is engaged with the teeth of the rack and the arrow
stamped on the rack is pointing up.
5
3
Fig. C
4. Slide the table assembly with the rack onto the column.
5. Engage the bottom of the rack (5) with the lip of the
column support (6). Tighten the table bracket lock handle
(4) to lock the table assembly to the column.
6. Install the rack ring (7) on the column so the top lip of the
rack sits into the rack ring.
IMPORTANT: The bottom of the collar MUST NOT be pushed
all the way down onto the top of the rack. MAKE SURE the
top of the rack is under the bottom of the collar and that there
is enough clearance to allow the rack to freely rotate around
the column. Tighten the set screw (8).
1
NOTE: To avoid column or collar damage, DO NOT OVER-
TIGHTEN the set screw.
4
1
7. Install the table crank handle (9) onto the worm gear shaft
8. Line up the flat side of the shaft with the set screw (10)
7
Fig. D
(11) on the side of the table support (12).
in the crank handle and tighten the screw with the 3mm
hex wrench provided.
4
3
5
6
8
7
5
Fig. E