KNOVA KN DP-2500N Manual Del Usuario página 12

ASSEMBLY AND ADJUSTMENTS
THE LASER GUIDE
Your tool is equipped with our latest innovation, the laser
guide, a battery powered device using Class IIIa laser beams.
The laser beams will enable you to preview the drill bit path on
the workpiece to be drilled before you begin your operation.
AVOID DIRECT EYE CONTACT
W A R N I N G
A laser light is radiated when the laser
guide is tumed on. Avoid direct eye contact. Always un-plug
the drill press from the power source before making any
adjustments.
• A laser pointer is not a toy and should not come into hands
of children. Misuse of this appliance can lead to irreparable
eye injuries.
• Any adjustment to increase the laser power is forbidden.
• When using the laser pointer, do not point the laser beam
towards people and /or reflecting surfaces. Even a laser
beam of lower intensity may cause eye damage. Therefore,
do not look directly into the laser beam.
• If the laser pointer is stored for more than three months
without use, please remove the batteries to avoid
damage from possibly leaking batteries.
• The laser pointer includes no servicing components. Never
open the housing for repair or adjustments.
• On units equipped with the laser attachment, repairs shall
only be carried out by the laser manufacturer or an
authorized agent.
• Laser Warning label: Max output <5mW Wavelength: 630
660nm, Complies with 21CFR 1040.10 and 1040. 11.
Class Illa Laser Product.
• CAUTION Use of controls or adjustments or performance
of procedures other than those specified herein may result
in hazardous radiation exposure.
• Do not attempt to repair or disassemble the laser level.
If unqualified persons attempt to repair this laser product,
serious injury may result. Any repair required on this laser
product should be performed by authorized service center
personnel.
• CAUTION The use of optical instruments with this product
will increase eye hazard.
ADJUSTING THE LASER LINES (FIG. R)
A. How to check the Laser beam Alignment?
1. Adjust the table height so it is 5 in. below the bottom of
the chuck.
2. Scribe a round circle (approx. 1/8 in.) on a piece of scrap
wood.
3. Insert a drill bit approx 1/8 in. diameter into the chuck and
tighten.
4. Lower the quill and align the scribed circle with the drill bit
and fasten the wood to the table.
5. Turn on the laser and verify the laser lines (x) are
centered onto the scribed circle.
B. ALIGNING THE LASER BEAM (FIG. R)
To adjust the laser lines:
1. Turn on the laser by pressing the rocker switch.
2. Lower the drill press quill and loosen one turn each the
four screws (4).
3. To adjust the laser beam left/right, turn the adjustment
screw (1) no more than 1/8 turn in either direction. To
adjust the laser beam front to back, turn the adjusting
screw (2) no more than 1/8 turn in either direction.
4. Once adjustments are completed, retighten the four
screws (4).
1
2
11
4
3
Fig. R
4