Ptz; Network Parameters - Steren CCTV-965 Manual De Instrucciones

Full disc you have two options: keep recording or stop recording. The selected action will be activated when the disk is full.
Camera selection: Use [↑] [↓] to select a camera.
Flow type: you can select between audio and video recording or video only.
Resolution: use it to set recording resolution. Options comes from lowest to highest.
Transfer rate: use it to set recording transfer rate.
FPS: higher FPS better image quality
Pre-recording time: use it to set the time after motion detection.
Post-recording time: use it to set the time to stop recording after motion detection.
Enable / Disable recording: use it to activate or deactivate recording for selected camera.
Time: use to select the time a camera will be activated.
You can set day, time and recording time for each camera. For recording type, the options are: motion detection, alarm and
motion and alarm.
Note: If you modify one of these options, you must restart the DVR.

Network parameters

Do not modify any of this parameters. Factory settings are designed to work with the DVR.

PTZ

If you connect a PTZ camera in RS-485 port, you can set the parameters.
26