Clearing Paper Jams - Olympia PS 705.4 CC Manual De Instrucciones

8

Clearing Paper Jams

If too much paper is fed into the cutting mechanism, a paper jam occurs. The shredder
switches off automatically in the event of a paper jam.
Proceed as follows:
Set the operating mode switch to REV to activate reverse running and feed the paper
●
back out.
Set the operating mode switch to FWD to clear the infeeds of any residual material.
●
If necessary, remove any residual material manually from the automatic paper infeed.
●
Set the operating mode switch to AUTO to reactivate the automatic function.
●
Reduce the quantity of paper being fed into the shredder.
●
8.1 Reverse running
Set the operating mode switch to its REV position so that the cutting mechanism runs
backwards and releases the paper.
Note: If a paper jam has occurred when the automatic paper infeed is in operation,
you must also check whether there is any residual paper in the automatic paper
infeed and remove it as well!
8.2 Forward running
Set the operating mode switch to FWD to draw in and shred any residual paper and clear
it from the cutting mechanism.
Note: The forward running setting must be used after clearing a paper jam to start the
cutting mechanism running without feeding any new paper through the infeed.
8.3 Removing residual paper from the automatic paper
infeed
1. Set the On/Off switch to its OFF position and disconnect the power plug from the
power socket.
2. Unlock the automatic paper infeed by setting the locking button to its OPEN position.
3. Hinge up the safety guard on the automatic paper infeed.
4. Remove any jammed paper carefully from the cutting mechanism using a suitable
tool.
5. Hinge the safety guard on the automatic paper infeed back down.
6. Lock the safety guard of the automatic paper infeed by setting the locking button to its
LOCK position.
7. Reconnect the power plug in the power socket and set the On/Off switch to ON.
22