Annual Maintenance; Chap 6 Adjustments And Settings; Dispenser; Rinse Agent Dispenser - Elettrobar FAST 140 Manual De Instrucciones

INSTRUCTION MANUAL FOR DISHWASHERS
GB
Have your appliance carefully inspected by an authorised technician, and in particular:
•
Remove residues from the bottom of the tank.
•
Remove and deep clean wash arms and diffusers.
•
Thoroughly clean the weir inserted in the lower wash arm shaft and the water exit area.
•
Correctly refit weir, pivoting pins and wash arms.
•
Inspect the conditions of the sealing gaskets and the wear of other components such as pumps,
dispensers, etc.
•
Inspect the settings of washing detergent and rinse agent dispensers.
•
Inspect and eventually clean the resistors.
If the appliance is not used for long periods of time, it is necessary to have it adequately setup. If
you have any suspects about the presence of ice, do not run the appliance until an authorised
technician has inspected boiler and pipes.
The following adjustment and setting operations may be carried exclusively by qualified
and authorised personnel, paying the utmost care and attention, and taking all
precautions in the event that safety features are bypassed.
•
The warranty does not cover damages resulting from improper use of the
dispenser(s) or incorrect manual feed.
•
Type and dosage of detergent and rinse agent are crucial in affecting the
appliance's performance and service life. Use only liquid products for industrial
washing with antifoaming agents.
•
Adjustments must be made with the appliance hot and correct amount of
washing product.
The level of rinse agent inside the container must be adequate; it must never be
completely emptied, or topped-up with corrosive or impure products. To fill up the supply
pipe and the dispenser, turn on the appliance and start the washing cycle, wait for
approx. 20 seconds and press the "On/off" button
approximately 10 seconds. Leave it pressed to let the cycle terminate.
•
Striations on washed items and the formation of foam within the washing solution indicate an
excessive quantity of rinse agent. Items covered with water drops and long drying time, indicate
Page 10 of 12

Chap 6 ADJUSTMENTS AND SETTINGS

Before the zeroing operation may be carried out,
dispenser(s) and supply pipes must be filled up. The
zeroing is performed via the adjusting screws which may
be reached by removing the front panel underneath the
tank door.
•
Turning the adjusting screw anticlockwise, reduces
the quantity of rinse agent released, while turning it
clockwise, increases the dosage.
•
For a rough estimate concerning the amount of rinse
agent required for the first zeroing operation, refer to
the dosage suggested by the manufacturer of the
product.
•
The screw adjustment must be refined on the basis of
the results obtained after at least three rinsing cycles,
so to let the system settle.

5.4 Annual Maintenance

6.1 Dispenser

6.1.1

Rinse agent dispenser

for 8-10 times with intervals of