INSTRUCTION MANUAL FOR DISHWASHERS
•
With the tank completely empty, clean the appliance as described in the "Maintenance"
paragraph.
•
Turn off the appliance whenever the overflow cap is removed.
If the machine is equipped with an internal softener (available on request), in order to ensure its
correct performance, it is necessary to periodically regenerate the ion exchange resins. The number
of cycles between each regeneration is set by the hardness of the water, according to the following
table.
No. of
dH
F
Cycles
6,0
10
153
6,5
11
147
7,0
12
140
7,5
13
133
8,0
14
127
8,5
15
120
9,0
16
113
•
It is suggested to carry out the regeneration during breaks.
•
Turn off the appliance as indicated in paragraph "Turning off the appliance".
•
Drain the appliance as indicated in paragraph "Discharging the appliance".
•
Clean the dishwasher as directed in chapter "Maintenance". At the end of the cleaning
procedure, open the main water tap and engage the main electrical switch.
1. Turn off the appliance as described in the "Turning off
2. Remove the overflow cap: wait until the tank is
1. Turn off the appliance as described in the "Turning off
2. Remove the overflow cap and shut the door.
3. Push the "discharging pump" button shown to drain.
START
4. On models without the "discharging pump button", turn
5. Remove the overflow cap and shut the door.
6. Push the "start" button, shown to drain.
No. of
dH
F
Cycles
9,5
17
107
10,0
18
100
10,5
19
93
11,0
20
87
12,0
21
83
12,5
22
80
13,0
23
77
4.6 Discharging the Appliance
4.6.1
Models without discharging pump
the Appliance" paragraph, above.
completely empty.
4.6.2
Models with discharging pump
the Appliance" paragraph, above.
off the appliance as described in the "Turning off the
Appliance" paragraph, above.
4.7 Regenerating the Ion Exchange Resins
No. of
dH
F
Cycles
13,5
24
73
14,0
25
70
14,5
26
67
15,0
27
63
15,5
28
60
16,0
29
57
17,0
30
53
GB
No. of
dH
F
Cycles
17,5
31
52
18,0
32
50
18,5
33
48
19,0
34
47
19,5
35
43
Page 7 of 12