Moser 1230 Traducción Del Manual De Uso Original página 12

ENGLISH
Operation
de
Preparation
Keep the packaging material for safe storage or
en
transport later.
f Check that the contents are complete.
fr
f Check all the parts for possible transport damage.
Safety
it
Handle with care! Damage due to incorrect
power supply.
es
f Only operate the appliance with an alternat-
ing current and with the voltage stated on the
nameplate.
pt
Mains operation
nl
1. Oil the blade set (Fig. 6).
2. Insert the appliance plug into the mains socket.
sv
3. Switch on the appliance using the on/off switch
(Fig. 2ⓐ) and, after use, switch it off again (Fig. 2ⓑ).
no
Operation
fi
Cutting-length adjustment
Without the attachment comb, the normal cutting length of
the appliance is approx. 0.1 mm. The cutting length can be
tr
adjusted between 0.1 and 3 mm, even when the appliance
is in use.
pl
1. Slide down the locking switch (B) (Fig. 3ⓑ)
2. By moving the adjustment lever at the side (Fig. 4ⓐ), it
cs
is possible to set the cutting length at 6 preset positions
(MultiClick).
3. Sliding the locking switch upwards (Fig. 3ⓐ) unlocks
sk
the setting and restores the normal cutting length of
approx. 0.1 mm.
hu
Cutting with the attachment comb
The appliance can also be operated with attachment
sl
combs. Attachment combs can be used to extend the cut-
ting length range.
ro
Depending on the model, various attachment combs are
included in delivery. Attachment combs #1 (4.5 mm), #2 (6
bg
mm), #3 (9 mm), #4 (14 mm), #5 (19 mm) and an adjust-
able attachment comb (4 - 18 mm) are also optionally
available as accessories.
ru
Accessories are available from your dealer.
uk
Attaching/removing the attachment comb
el
The adjustment lever used to adjust the cutting
length must not be locked (Fig. 4ⓑ).
ar
f Slide the locking switch (B) upwards (Fig. 3ⓐ)
12
1. Slide the attachment comb onto the blade set in the
direction of the arrow until it reaches the limit stop
(Fig. 5ⓐ).
2. Slide the attachment comb off the blade set in the
direction of the arrow (Fig. 5ⓑ).
Replacing the blade set
Warning! Injuries and material damage due to
incorrect handling.
f Switch the appliance off and disconnect from
the power supply before changing the blade
set.
1. Switch the appliance off using the on/off switch (Fig. 2)
and disconnect from the power supply.
2. Undo both screws on the blade set; remove the bottom
blade and the top blade (Fig. 8).
When assembling, the bottom blade and the top blade
should be aligned as follows:
3. Set the locking switch (B) for the cutting length
(Fig. 3ⓐ) and the adjustment lever (Fig. 4ⓑ) to the
shortest cutting length.
4. Place the top blade with groove on the wedge-shaped
plastic guide and press it down at the back so that the
drive pin grips the blade cutout.
5. Position bottom blade and reinsert the two screws.
6. Before tightening the screws, align the bottom blade
(Fig. 7).
Warning! Injuries due to incorrect handling.
f Align the bottom blade so that there is a gap
of 0.5 mm to 1.0 mm between the front edge
of the bottom blade and the front edge of the
top blade (Fig. 7).
7. Tighten both screws (Fig. 8).