Cleaning And Care; Troubleshooting - HoMedics PED-1200 Manual De Instrucciones

C H A N G I N G T H E R O L L E R S
T O R E M O V E T H E R O L L E R
1. Ensure the switch is in the OFF position.
2. With one hand press the release button on the side of
the device.
3. With the other hand lift out the roller.
TIP: It's easier to lift the roller out from the end closest to the
release button.
T O I N S E R T A N E W R O L L E R
1. Loosely position one of the roller pins into the recess on the
end furthest from the release button.
2. Push the other end of the roller into place using the groves
to guide it into position.
3. The roller will secure into place with a click
C L E A N I N G A N D C A R E
Always turn the device off and remove the batteries before cleaning.
T O C L E A N T H E S U R F A C E
Clean the surface of the unit with a clean, damp, soft cloth
• NOTE: Never allow water or any other liquids to come in
contact with the unit
• Only clean the rollers with the supplied brush
• Never use abrasive cleaners to clean the unit
6 6
C L E A N I N G A N D C A R E
T O S T O R E
• Remove batteries if equipment is not going to be used for extended periods of time.
• Place the components into its box and store in a safe, dry place
B A T T E R Y P R E C A U T I O N S
• Do not mix old and new batteries.
• Use only the size and type of batteries specified.
• Do not dispose of batteries in fire. Batteries may explode or leak.
• When installing batteries, observe proper +/- polarities. Incorrect installation of battery may
cause damage to the unit.
• Do not mix alkaline, standard (carbon-zinc), or rechargeable (ni-cad, ni-mh, etc) batteries.
• Clean the battery contacts and also those of the device prior to battery installation.
• Remove used batteries promptly.
• If the unit is not going to be used for a long period of time, remove batteries to prevent
damage due to possible battery leakage.
• Recycle or dispose of properly in accordance with all local, state, province, and country
regulations.
T R O U B L E S H O O T I N G
PROBLEM POSSIBLE CAUSE
Motor power seems • Low batteries
reduced
Roller surface appears
• Dirty
worn or less abrasive
• Roller needs replacing
SOLUTION
• Replace the batteries
• Brush clean with cleaning brush
(included)
• Replace the roller
7 7