C L E A N I N G A N D C A R E
CAUTION: Before cleaning the unit, turn power off, make sure it is disconnected from the charging
cord and the charging port cover is plugged into the charging
T O C L E A N T H E S U R F A C E
Before cleaning, be sure the charging port cover is fully inserted into the
charging port. Thoroughly clean the surface of the unit after every use with
soap and water. Pat dry with a clean, soft cloth.
NOTE: Never use abrasive cleansers to clean the surface of the unit. It
may decrease the life of your product.
CAUTION: DO NOT try to remove the silicone sleeve after using or during
cleaning. Doing so will destroy the unit.
T R O U B L E S H O O T I N G
PROBLEM
POSSIBLE CAUSE
Unit will not operate
• Unit is not charged
• Unit is locked
Buttons do not work
8
port.
SOLUTION
• Charge the unit by connecting it to the charging cord and
adapter and plugging it into an electrical outlet.
• Press and hold the POWER BUTTON for 2 seconds to
turn the power on.
• Check circuits, fuses, try a different outlet.
• Press and hold both the + and – buttons for 2 seconds to
unlock the unit.
• Fully charge the unit by connecting it to the charging
cord and adapter and plugging it into an electrical outlet.
When fully charged, the unit will automatically unlock.
F C C S T A T E M E N T
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
The manufacturer is not responsible for any radio or TV interference caused by
unauthorized modifications to this equipment. Such modifications could void the user authority
to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
This class B digital device complies with Canadian ICES-003.
9