Selecting The Method To Connect: Via Wireless Lan Or Other Method; Connecting Via A Wired Lan; Checking Before The Setup; Connecting Via A Usb Cable - Canon imageCLASS LBP253dw Introducción

Selecting the Method to Connect:
Via Wireless LAN or Other Method
Do you want to use the
wireless LAN to connect
the computer?
The settings can be
configured later.
Yes
There is a button.
Start from step 4 of "Push Button Mode" (P. 11).
Yes
There is no button.
Start from step 4 of "Setting the Access Point
Manually" (P. 12).
Connect to the computer via a wired LAN
Proceed to "Connecting via a Wired LAN" (P. 10).
Connect to the computer via a USB cable
No Proceed to "Connecting via a USB Cable" (P. 10).
Connect to the computer via a wireless LAN later
Proceed to "Connecting via a Wireless LAN" (P. 11).

Connecting via a Wired LAN

Checking before the Setup

Internet
Are the computer and the router (or hub) properly
connected using a LAN cable?
For more information, see the instruction manual for the
network device you are using, or contact the networking
device manufacturer.
Have the network settings on the computer been
En
completed?
If the computer is not properly configured, you may not use
the wired LAN connection even after completing the following
settings.
NOTE
• You cannot connect both the wired LAN and wireless
LAN at the same time. In addition, the machine is set to
the "Wired LAN" by default.
• When you connect to a network environment that is not
security protected, your personal information could be
disclosed to third parties. Please use caution.
• If you connect through a LAN in the office, contact your
network administrator.
10
No
Router
or
hub
LAN cable
Connecting via a Wired LAN
1
Connect the LAN cable.
The IP address will be automatically configured in 2
minutes. If you want to set the IP address manually, see
the following items.
►
e-Manual "Network"
"Setting IP Addresses"
2
Install the driver and software using the provided
DVD-ROM.
See "For details on the installation procedures:" (P. 13).
Proceed to "Setting the Paper Size and Type" (P. 13).

Connecting via a USB Cable

Install the driver and software on the DVD-ROM included with
the machine.
NOTE
If you connected the USB cable before installing, first
remove the USB cable, and then re-install.
1
Install the driver and software using the User
Software and Manuals DVD-ROM.
See "For details on the installation procedures:" (P. 13).
2
Connect the USB cable.
Proceed to "Setting the Paper Size and Type" (P. 13).
►
"Connecting to a Network"