Initial Use; Cleaning And Maintenance - Princess 232700 Manual De Instrucciones

Congratulations!
You have purchased a Princess product. Our aim
is to provide quality products with a tasteful
design and at an affordable price. We hope
that you will enjoy this product for many years.
Description (fig. A & B)
Your 232700 Princess water boiler has been
designed for boiling water. The appliance has
a removable filter in the spout (fig. B). The
appliance is not suitable for boiling liquids
other than water. The appliance is suitable for
indoor use only. The appliance is suitable for
domestic use only.
1. On/off switch
2. On/off indicator
3. Water boiler
4. Water level indicator
5. Lid
6. Lid release button
7. Handgrip
8. Base
9. Removable filter

Initial use

Preparation (fig. A & B)
• Clean the appliance. Refer to the section

"Cleaning and maintenance".

Before you proceed, we need you to pay
attention to the following notes:
­ Before first use, completely fill the water
boiler with water without using the water
for consumption or other purposes.
• Fill the water boiler (3) with water up to the
maximum mark on the water level indicator
(4).
• Boil the water. Refer to the section "Boiling
water".
• Empty the water boiler (3).
Use
Boiling water (fig. A & B)
Before you proceed, we need you to pay
attention to the following notes:
­ Before filling the water boiler, always remove
the water boiler from the base.
­ Only use tap water to fill the water boiler.
­ Always make sure that the water level is
between the minimum mark and the
maximum mark on the water level indicator
(fig. A). If the water level is below the
minimum mark, the water boiler will boil
dry. If the water level is above the maximum
mark, the water boiler will boil over and hot
water will spray out.
­ Do not remove the water boiler from the base
until the appliance has been switched off.
• Place the appliance on a stable and flat
surface.
• Remove the water boiler (3) from the base
(7).
• Open the lid (5) by pressing the lid release
button (6).
• Fill the water boiler (3) with water.
• Place the water boiler (3) onto the base (7).
• Insert the mains plug into the wall socket.
• To switch on the appliance, press the on/off
switch (1). The on/off indicator (2) comes
on. The appliance starts to boil the water.
• To interrupt the process, release the on/off
switch (1).
• If the process is completed, the appliance
switches off automatically. The on/off
indicator (2) goes off.
Cleaning and maintenance
Before you proceed, we need you to pay
attention to the following notes:
­ Before cleaning or maintenance, remove
the mains plug from the wall socket and
wait until the appliance has cooled down.
­ Do not immerse the appliance in water or
other liquids.
Before you proceed, we would like you to
focus your attention on the following notes:
­ Do not use aggressive or abrasive cleaning
agents to clean the appliance.
7