Heating Function - DeLonghi TRRS2715EBK Manual De Instrucciones

DESCRIPTION
A
display
B on-standby button
C increase button
D
decrease button
E power button
F eco button
G
timer button
H
cord holder
I wheel
USE
"Easy wheel" system
Turn the radiator upside down on a rug or a soft surface in
order to prevent damaging the paint nish.
Fully unfold the wheels by turning them outwards (Fig. 1).
Turn the radiator back to its upright position.
Fig. 1
Location
The heater must not be placed immediately below a power
outlet. Do not use this radiator in rooms having a surface area
of less than 43 square feet (4 sq.m.).
Power connection
- Before using the appliance check that your supply
voltage is the same of that shown on the rating label
of the unit and that the power socket and power supply
line correspond to the load speci ed.
- Check also the current capacity of your fuses. CONNECT
YOUR HEATER DIRECTLY TO GROUNDED WALL SOCKET
ONLY.
Plug in the heater, the appliance will be set in the stand-
by condition. The display will show the
loose clothing or bedding, furniture and ammable material
away from the power outlet where the heater is plugged in.
After an interruption of the power supply (power failure or
appliance unplugged) the unit goes always to stand-by.

Heating function

To turn the appliance on, press the
Press button (E) to set the required power level:
MIN ( ); MED ( ); MAX (
temperature, press button + or - (C or D). By pushing the +
symbol. Keep
(B) button.
). To select the desired
6
or - button once, the temperature (shown on the display) will
increase or decrease by 1 °F (1 °C). By keeping the + or -
button depressed, the value will increase or decrease rapidly.
The appliance allows you to set the temperature from 41°F
(5°C) to 82°F (28°C).
Anti-freeze function
Setting the temperature to 41°F (5°C) with the "-" button,
the appliance will activate the Antifreeze function.
The display will show the
will turn on automatically, at the max power, only if the room
temperature falls below 41°F (5°C).
If you wish to go back to the Heating function, press the
"+" button once. After an interruption of the power supply
(probe failure or appliance unplugged) the unit goes always
to stand-by.
Eco function
When this function is active the appliance automatically sets
the most appropriate power level to guarantee optimum
comfort while reducing energy consumption.
To activate this function press the "ECO" (F) button. The
display will show symbol. If the selected temperature
is much higher than the actual room temperature, the
appliance will start automatically and rapidly begin to heat
the room. The appliance will automatically select the most
convenient power level (MAX-MED-MIN-OFF).
If MAX power level has been selected using the
button, the appliance will cycle between: MAX-MED-MIN-
OFF.
If MED power level has been selected, the appliance will cycle
between: MED-MIN-OFF.
If MIN power level has been selected, the appliance will cycle
between: MIN-OFF.
Working indicator
The symbol indicates the heating status by means of its
colors.
RED: the unit is heating at the maximum power.
ORANGE: the unit is heating at the medium power.
symbol, in this way the appliance